Instructor
Check the frequently asked questions about this course.
This course includes 4 modules, 8 lessons, and 3:50 hours of materials.
Crude oil is a mixture of thousands of hydrocarbons, from light gases to heavy tar. Two properties matter most to a refiner: density, often given as API gravity, and sulphur content. Light, low-sulphur crude is called light sweet and is easier to refine; heavy, high-sulphur crude is harder and usually cheaper.
A refinery makes a family of products: LPG, gasoline, naphtha, jet fuel, diesel, fuel oil and bitumen. Each has its own boiling range and its own market. A refinery's layout can be drawn as a map of units that turn the crude into the mix of products the market wants.
Crude is first washed to remove salt, then heated in a furnace and fed into a tall column. Inside, vapour rises and cools; each product condenses at its own height, so naphtha, kerosene and diesel can be drawn off from different trays. The unfinished heavy liquid collects at the bottom.
The heavy liquid from the bottom of the first column would break down if heated much further. Instead it is fed to a second column running under vacuum. Lowering the pressure lowers the boiling points, so more valuable oil can be recovered without damaging it.
Cracking breaks large molecules into smaller ones. In a fluid catalytic cracker, hot powdered catalyst turns heavy oil into gasoline and lighter gases. Hydrocrackers use hydrogen and pressure to make diesel and jet fuel, and cokers use heat to turn the heaviest residue into lighter liquids and solid coke.
Hydrotreating passes a stream over a catalyst with hydrogen to remove sulphur and other impurities, so fuels meet clean-fuel limits. Catalytic reforming reshapes low-octane naphtha into high-octane gasoline blend stock and makes hydrogen as a by-product that the hydrotreaters then use.
A refinery uses large amounts of steam, electricity, cooling water, compressed air and fuel gas. These utilities are the unseen backbone of the plant: if they fail, process units must shut down. Heat integration, where hot streams warm cold ones, saves fuel and cuts emissions.
Refineries handle flammable liquids and gases at high temperature and pressure, often with toxic materials such as hydrogen sulphide. Most serious incidents start with a small release that finds an ignition source. Good practice keeps hydrocarbons inside the equipment and controls every job that could open it.
Reply to Comment